Lesson 1 Configure your device


In this lesson, you configure your Linkit 7688 device with an operating system, set up your development environment, and deploy an application to Linkit 7688.

There are three parts:


A: What will you need


B: Set up your Linkit 7688(Duo) connect the network



Part A: What will you need & Getting start



  • What will your need

    • LinkIt 7688 (Duo)

    • Power Supply :

      • The LinkIt 7688 is powered by a USB Micro power supply with at least 1A at 5V.



    • Wi-Fi AP



  • Power on your LinkIt 7688(Duo)
    Power (PWR) connector, not the USB host (HOST) connector near the MPU reset button. The green ON LED (Power on) will light up, followed by a blink from the orange Wi-Fi LED (bootloader initialization). After about 5 seconds, the device boot up starts and the orange LED will light up solid for about 30 seconds.


S__58081282_2

Part B: Connect your LinkIt 7688(Duo) to the network



  • Turn on the AP mode

    • After boot up, the Wi-Fi LED will turns off. This means the system is ready to accept a Wi-Fi connection.

    • If not, press the Wi-Fi Reset button for at least 5 seconds and release to turn on the AP mode.




wifirest

  • Consult the below image for the Wi-Fi LED Status and System Status. (image source : Media Tek Lab)


image003

image source : Mediatek Lab





  • Go to your Wi-Fi settings and choose "LinkIt_Smart_7688_XXXXXXX". (where “XXXXXXX” is the MAC address of your LinkIt 7688 (Duo)).




 

圖片 1

linkit_設定密碼

  • After logging in, go to the "Network" tab and select "Station Mode" to set up the Wi-Fi AP you will connect to. Your PC and LinkIt must be on the same network. Click "CONFIGURE & RESTART".


linkit_設定網路

  • Change your PC network to the same as the LinkIt network.




Please visit QNAP github for QIoT Suite Lite sample code


"QNAP-Github"

arrow
arrow
    全站熱搜

    tttt 發表在 痞客邦 留言(0) 人氣()