觀察筆記

Step_1: Open QVR Pro and set the event

•  For information on installing QVR Pro, please visit https://www.qnap.com/en/how-to/tutorial/article/how-to-install-qvr-pro-beta


•  Once installed, start QVR Pro, and open "Event Management".

• Click "＋" to create a new rule.

• Enter a "Name" (for example: QIoT). (The "Description" is optional)


• Click "Next".

• In "If -->The following event(s) occur", click "Add".

• In "Add Event":
  
  
  
  1. Name: Enter a preferred name (for example: "QIoT").
  
  
  2. Type: Choose "Event URL".
  
  
  
  

• Enter an "Event source name" (for example: "temp").


• After entering the Event source name, a URL link will appear. Click "Copy to Clipboard".


• Click "OK".

• In "Then -->Perform the following action(s)", click "Add".

• In "Add Action":
  
  
  
  1. Name: Enter a preferred name (for example: "Action").
  
  
  2. Type: Choose "Event Recording".
  
  
  
  

• In "Items":
  
  
  
  1. Choose a camera ( If you have not set up a camera, refer to the Quick Setup Tutorial of QVR Pro Beta 0.8 for instructions)
  
  
  2. Click "OK".
  
  
  
  

• Click "Next".

• Click "Finish".

Step_2: Setting QIoT Rule http request node

• Open your IoT Application and click "Rule".


• In "function", choose "switch" and "http request", and then pull them into Flow 1.

• Click "Switch". (In here, set up the rules yourself).

• Click "http request":
  
  
  
  1. In "URL: Enter the URL link you have copied from QVR settings. (If QVR Pro and QIoT are used in the same NAS, the IP address must be changed to "10.0.7.1")
  
  
  
  


• Click "Done" and "Save".

• If QIoT received the rules settings it will notify QVR Pro to capture video. You will see the message "event [temp] detected".